Protección contra sobretensiones Ethernet de alta eficiencia para LAN, PTF-1-EXT/PoE

Protección contra sobretensiones de alta eficiencia para cámaras de 100Mbit Ethernet y CCTV IP, protección contra sobretensiones incorporada para PoE, fusible MOSFET súper rápido incorporado para aumentar el nivel de protección, fabricante, PTF-1-EXT / PoE

Product discontinued - has been replaced by PTF-51-EXT/PoE

 

PTF-1-EXT/PoE is a high-efficiency surge protection for 100Mbit Ethernet and IP CCTV cameras. In series Extreme using the latest solution in the form of super fast fuse MOSFET. It protects from effects of surge and lightning and vandalism (effect of stun guns). It may be using in systems of local LAN network to protection of overhead lines between buildings, to protects connections between switches for cable of 6 category. The device has individually protection of each transmission pair, where after crossing voltage above 90V, followed short circuit its to ground. 4, 5 and 7, 8 cables are connected together, to increase current flowing for a PoE standard (Power over Ethernet). By using innovative components PTF-1-EXT/PoE Protection has very low capacity and high reaction speed, which have negligible effect on high-frequency signals transmitted, very short reaction time and ability to multiple response.

Built-in automatic fuses protects PoE power supply from damage, in event of short circuit at power supply of receiving device. Also built-in LEDs, signaling presence of power supply entering and exiting from PTF-1 protection.

Construction of circuit is completely shielded from bottom and from top, which provides high immunity to electromagnetic interference and continuity of screen between input and output. Screen has independent circuit protection, so that it is not permanently connections with ground. This is important for risk of potential differences and appearing of parasitic signals.

 

 
zabezpieczenie przeciwprzepięciowe do kamer IP
Simplified block diagram

Because discharge may occur on either side, a road transmitted by load can take a long time. To increase effectiveness of protection is recommended to use surge protections at both ends of cable.


Zabezpieczenie przepięciowe PTF-1-EXT/PoE

Example of surge protection one connection of the LAN


zabezpieczenie instalacji EXTREME

Example of surge protection sixteen connections of the LAN






Technical Specification:

Parametr
VALUE
Level protection 3 (Gas tube, Fuse MOSFET, Transil)
Category 100Base-T(100Mbit) network,
using 5/5e/6 category twisted-pair
Capacity line- line 6-8pF @ 0V, 1Mhz
Capacity line-ground < 1pF
Level protection line-line 6V-1kV, 20V @ 100A , 8/20uS
Level protection line-ground 90V-4kV, 2~4kA, 8/20uS Vc
Maximum voltage Uc 6,8V
Maximum power 8/20uS (line-line) 2kW
Maximum voltage line-line 90VDC
Line PoE
Level protect 2 (Gas tube, Transil)
Level protect line-line for PoE 10/1000uS 600W / 100A, 10/1000uS
Maximum voltage Uc of PoE 58V
Level protect line- ground 90V-4kV, 2~4kA, 8/20uS
Mazimum voltage line-ground 90VDC
Standard work PoE  IEEE 802.3af mode B
 
Connectot input (line) RJ-45
Connector output (device) RJ-45
Socket ground Yes
Temp -40~+60°C